Technical Specs

Antenna Signal Strength -35 to -85 dBm (Recommended), Absolute Maximum=+12 dBm
Antenna port isolation for
concurrent operation
Up to +5 dBm signal strength for 2.4 GHz signal
Integrated Antenna Port
Protection
>20 KV (Human Body Model)
Receiver LNA Gain >10 dB
Receiver Adjacent Channel
Rejection (ACR)
>18 dB @ 11g, 6 Mbps (Typ)
Receiver Alternate Channel
Rejection (ALCR)
>35 dB @ 11g, 6 Mbps (Typ)
Receive chain Noise Figure +6 dB
Transmitter Adjacent Channel
Leakage power Ratio (ACLR)
45 dB (Fc ± ChBW)
Transmitter Spurious
Emission Suppression
-40 dBc
RF Power control
In 0.5 dBm steps. Accuracy of power calibration loop ±2 dBm. Each
transceiver individually calibrated and tested.
RF Hardware Disable (RF
Kill)
Pin 20 of miniPCI-E interface. (Required for FAA compliance)
Control for External Power
Amp
Available as an optional configuration
Spectral Analysis 8 bit resolution spectral FFTs available for software analysis
PHYSICAL, ENVIRONMENTAL AND OTHER SPECIFICATIONS
Antenna Ports 2 Ports (50 Ohms) with MMCX connectors.
Host Interface miniPCI-Express 1.2 Standard
Host CPU Board
Any CPU board with Industry standard miniPCI-Express interface with
minimum 6 mm connector height
Operating Voltage 3.3 Volts from miniPCI-Express connector
Power Consumption
4W @ Max power, in continuous data transfer mode on all chains
2.8W @ 25 dBm power, in continuous data transfer mode on all chains
2W @ 20 dBm power (ETSI max), in continuous data transfer mode on
all chains
0.7W in continuous data receive mode
230 mW in Sleep mode
Shield case temperature
range (Operating)
-40°C to +80°C
The System’s thermal design should ensure that the transceiver’s case
temperature is maintained within these specifications.
Humidity (Operating) 0% – 95% (Non-condensing)
Dimensions
30 x 50 x 7 mm, 14 grams
Mechanical drawing and 3D-CAD files available upon request
Regulatory Requirements
Designed and Verified to meet various regulatory requirements.
Formal testing and approval is required based on the Integrator’s
particular host platform and antenna type. The Integrator is also
responsible for obtaining all required regulatory approvals in target
markets for the finished product.
FCC ID
CE/ETSI Q3 2016
Industry Canada (IC) Q3 2016
RoHS/WEEE Compliance Yes. 100% Recyclable/Biodegradable packaging
2ATBY-NMDB-2