User's Manual

WASP™ NEST2 Smart Receiver and Gateway Operations Manual
- 8 -
To attach the antenna, carefully screw the antenna cable to the SMA connection at the base of
the BossPac NEST™ Receiver Gateway. See photo below. Attach antenna to opposite end of
cable, (N type connector).
Figure 1: Attach Antenna to NEST
WARNING – EXPLOSION HAZARD. DO NOT CONNECT OR DISCONNECT THE ANTENNA IN A
HAZARDOUS ENVIRONMENT.
AVERTISSEMENT – RISQUE D’EXPLOSION. NE PAS BRANCHER OU DЀ-BRANCHER L’ANTENNE
DANS UN ENVIRONMENT FLAMMABLE.
2.3.3 Wiring NEST Circuit Board
The rear cover, (backplate), needs to be removed to access the following connections:
Power (+5 to24V), GND, Inputs and Outputs, RS485, USB and SD Card connections.
Figure 2: NEST Circuit Board
Block