User's Manual

WASP™ NEST2 Smart Receiver and Gateway Operations Manual
- 24 -
3.2.9.6 Setting Velocity Warning and Critical Alarm Thresholds
To set the desired velocity warning and critical alarm
thresholds for each individual sensor, select the
desired option from the SENSOR SETTINGS screen,
HI VEL / HI-HI VEL / LO VEL / LO-LO VEL
The bottom left quadrant of the screen will display
the current setting (in mm/s) or DISABLED if there is
no current threshold setting. Select or modify the
desired maximum warning or maximum critical value
by tapping the UP / DOWN and LEFT / RIGHT
arrows. Once the desired value has been selected press OK to save or CANCEL the editing
and return to the SENSOR SETTINGS screen.
3.2.9.7 Setting Sensor Lost Warning
A warning can be issued to alert that a sensor has not
reported to the NEST Receiver for a pre-determined
timeframe.
To set the amount of elapsed time a sensor can go
without reporting, scroll down to, and highlight the
LOST WARN parameter, and tap SELECT to access
the LOST SENSOR WARNING screen.
The bottom left quadrant of the screen will display the
current setting (in minutes) or 0000 if no setting. Tap
the UP / DOWN and LEFT / RIGHT arrows to set the
desired value and OK to save. Press CANCEL to
cancel the editing and return to the SENSOR
SETTINGS screen.
3.2.9.8 Setting Temperature Multiplier Factor
To change the default setting highlight the parameter
and modify the PERCENT factor using the UP/DOWN
and LEFT/RIGHT arrows. Tap OK to save.