User's Manual
WASP™ NEST2 Smart Receiver and Gateway Operations Manual
- 14 -
3.2.2.4 Set Modbus Parameter
To configure MODBUS parameters, select SET
MODBUS PARAM from the SYSTEM SETTINGS
selection screen. A submenu will display the
parameters to select: RTU ADDRESS, BAUD RATE,
or STOP BITS. If the direct output option was enabled,
you would be asked to disable it before modifying
MODBUS parameters.
3.2.2.4.1 RTU Address
Configure the RTU ADDRESS of the receiver by
using the arrow keys to navigate and input the digits.
3.2.2.4.2 BAUD Rate
Configure the BAUD RATE of the receiver to either
9600 or 19200 by using the arrows on the right of the
screen and choosing SELECT.
3.2.2.4.3 Stop Bits
Configure the STOP BITS of the receiver to either 1
or 2 by using the arrows on the right of the screen
and choosing SELECT.
MODBUS SET> ADDRESS
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
BACK
OK
RTU ADDR
001
1 BIT
2 BITS
MODBUS SET> STOP BITS
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
BACK
SELECT
1 BIT