User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 2.1 Included In The Package
- 2.2 Installation
- 2.3 Wiring NEST Receiver
- 3. Interface
- 3.1 System Status Screens
- 3.2 Main Menu
- 3.2.1 System Info
- 3.2.2 System Settings
- 3.2.3 LOGS
- 3.2.4 Sensor Lists
- 3.2.5 Alarm Overide
- 3.2.6 Diagnostic
- 3.2.7 Configuring Individual Sensors
- 3.2.7.1 Setting Sensor Name
- 3.2.7.2 Setting Update Rate
- 3.2.7.3 Setting Sensor Vibration Axes
- 3.2.7.4 Setting Temperature Warning and Critical Alarm Thresholds
- 3.2.7.5 Setting Acceleration Warning and Critical Alarm Threshold
- 3.2.7.6 Setting Velocity Warning and Critical Alarm Thresholds
- 3.2.7.7 Setting Sensor Lost Warning
- 3.2.7.8 Setting Temperature Multiplier Factor
- 3.2.7.10 Temperature Calibration
- 4. Maintenance
- 5. Contact Info
WASP™ NEST4 Smart Receiver and Gateway Operations Manual
- 7 -
3. Interface
The touch screen interface on the
BossPac NEST™ displays important
current information throughout all its
screens. The name of the current screen
is displayed at the top center. The current
time and date are displayed at the bottom
right. Current critical error count and
warning count are displayed in the
bottom left of the interface. These
information sections, top bar and bottom
bar of the touch screen, are not
interactive and are only intended to
provide current system statistics to the
viewer.
NOTE: Warnings indicate a sensor(s) has reached the warning limit pre-determined in the
Sensor Setup screen. Critical Alarms indicate a sensor(s) has reached
the pre-determined shutdown limit and a shutdown signal has been issued.
See the section of this manual on “Configuring Individual Sensors” for details about
setting warning and critical alarm limits.