User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 2.1 Included In The Package
- 2.2 Installation
- 2.3 Wiring NEST Receiver
- 3. Interface
- 3.1 System Status Screens
- 3.2 Main Menu
- 3.2.1 System Info
- 3.2.2 System Settings
- 3.2.3 LOGS
- 3.2.4 Sensor Lists
- 3.2.5 Alarm Overide
- 3.2.6 Diagnostic
- 3.2.7 Configuring Individual Sensors
- 3.2.7.1 Setting Sensor Name
- 3.2.7.2 Setting Update Rate
- 3.2.7.3 Setting Sensor Vibration Axes
- 3.2.7.4 Setting Temperature Warning and Critical Alarm Thresholds
- 3.2.7.5 Setting Acceleration Warning and Critical Alarm Threshold
- 3.2.7.6 Setting Velocity Warning and Critical Alarm Thresholds
- 3.2.7.7 Setting Sensor Lost Warning
- 3.2.7.8 Setting Temperature Multiplier Factor
- 3.2.7.10 Temperature Calibration
- 4. Maintenance
- 5. Contact Info
WASP™ NEST4 Smart Receiver and Gateway Operations Manual
- 24 -
4. Maintenance
4.1 Rear Cover
The rear cover of the NEST receiver should remain in place during operation. Do not remove
except to access the NEST circuit board when necessary. Replace rear cover upon completion
of task.
4.2 Replacing Batteries
The BossPac NEST™ Receiver uses a 3V Lithium Battery to maintain clock and memory function.
After several years of use the battery may need to be replaced. Use a standard CR2032 Lithium
Coin Cell. In some models the battery is a component of the circuit board and replacement is not
necessary.
WARNING – DO NOT CONNECT OR DISCONNECT BATTERY UNLESS AREA IS KNOWN
TO BE NON-HAZARDOUS.
NE PAS BRANCHER OU DÉ-BRANCHER LA BATTERIE DANS UN ENVIRONMENT FLAMMABLE.
5. Contact Info
BossPac engineers can be reached at:
Email: support@bosspac.com Web: www.bosspac.com
Phone: +1 403-216-1226 Toll Free: 866-616-1226
BossPac Engineering & Technology
1450 28th Street NE, Bay 8, Calgary, Alberta, CANADA T2A 7W6