User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 2.1 Included In The Package
- 2.2 Installation
- 2.3 Wiring NEST Receiver
- 3. Interface
- 3.1 System Status Screens
- 3.2 Main Menu
- 3.2.1 System Info
- 3.2.2 System Settings
- 3.2.3 LOGS
- 3.2.4 Sensor Lists
- 3.2.5 Alarm Overide
- 3.2.6 Diagnostic
- 3.2.7 Configuring Individual Sensors
- 3.2.7.1 Setting Sensor Name
- 3.2.7.2 Setting Update Rate
- 3.2.7.3 Setting Sensor Vibration Axes
- 3.2.7.4 Setting Temperature Warning and Critical Alarm Thresholds
- 3.2.7.5 Setting Acceleration Warning and Critical Alarm Threshold
- 3.2.7.6 Setting Velocity Warning and Critical Alarm Thresholds
- 3.2.7.7 Setting Sensor Lost Warning
- 3.2.7.8 Setting Temperature Multiplier Factor
- 3.2.7.10 Temperature Calibration
- 4. Maintenance
- 5. Contact Info
WASP™ NEST4 Smart Receiver and Gateway Operations Manual
- 22 -
3.2.7.6 Setting Velocity Warning and Critical Alarm Thresholds
To set the desired velocity warning and critical alarm
thresholds for each individual sensor, select the
desired option from the SENSOR SETTINGS screen,
HI VEL / HI-HI VEL / LO VEL / LO-LO VEL
The bottom left quadrant of the screen will display the
current setting (in mm/s) or DISABLED if there is no
current threshold setting. Select or modify the desired
maximum warning or maximum critical value by
tapping the UP / DOWN and LEFT / RIGHT arrows.
Once the desired value has been selected press OK to save or CANCEL the editing and return
to the SENSOR SETTINGS screen.
3.2.7.7 Setting Sensor Lost Warning
A warning can be issued to alert that a sensor has not
reported to the NEST Receiver for a pre-determined
timeframe.
To set the amount of elapsed time a sensor can go
without reporting, scroll down to, and highlight the
LOST WARN parameter, and tap SELECT to access
the LOST SENSOR WARNING screen.
The bottom left quadrant of the screen will display the
current setting (in minutes) or 0000 if no setting. Tap
the UP / DOWN and LEFT / RIGHT arrows to set the
desired value and OK to save. Press CANCEL to
cancel the editing and return to the SENSOR
SETTINGS screen.