User's Manual

Table Of Contents
WASP™ NEST4 Smart Receiver and Gateway Operations Manual
- 14 -
3.2.2.7 Set Pressure Units
You can set the units of pressure to either BAR or PSI by selecting SET PRESS UNITS from the
SYSTEM SETTINGS menu. Simply choose the unit of measurement and press SELECT.
3.2.2.8 Set Level Units
You can set the units to either METERS or FEET by selecting SET LEVEL UNITS from the
SYSTEM SETTINGS menu. Simply choose the unit of measurement and press SELECT.
3.2.2.9 Clearing All Sensors
You can clear all sensors from the NEST’s memory by
choosing CLEAR SENSORS from the System menu.
Once in the SENSOR SETTINGS> CLEAR ALL
screen tap OK to clear the sensors or CANCEL to go
back to the System screen.
WARNING CLEARING ALL SENSORS WILL REMOVE THE SENSORS AND ALL SETTINGS FROM
THE NEST’S MEMORY. BE SURE THIS IS WHAT YOU INTEND TO DO BEFORE CLICKING “OK”
MISE EN GARDE CLEAR ALL” DЀGAGE LA LISTE DE CAPTEUR ET TOUT LEUR
PARAMЀTRAGE. SOYEZ SURE AVANT DE CLIQUER “OK”
3.2.2.10 Adjust Brightness
The adjust brightness option allows you to change the
brightness of the screen to improve the readability of
the screen under different lightning conditions. *Note:
the higher level of brightness will increase the current
consumption.
You can adjust and set the screen brightness by
choosing ADJUST BRIGHTNESS from the SYSTEM
SETTINGS menu. In the ADJUST BRIGHTNESS
screen use the UP/DOWN arrows to change the
brightness level and tap DONE to save the level.
CLEAR
SENSOR SETTINGS
SENSOR SETTINGS> CLEAR ALL
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
OK
ADJUST BRIGHTNESS
21'C CRI=4 WRN=1 13:46 DEC 10/10
BRIGHTNESS
LEVEL
7
DONE
CANCEL
BACK