User's Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 2.1 Included In The Package
- 2.2 Installation
- 2.3 Wiring NEST Receiver
- 3. Interface
- 3.1 System Status Screens
- 3.2 Main Menu
- 3.2.1 System Info
- 3.2.2 System Settings
- 3.2.3 LOGS
- 3.2.4 Sensor Lists
- 3.2.5 Alarm Overide
- 3.2.6 Diagnostic
- 3.2.7 Configuring Individual Sensors
- 3.2.7.1 Setting Sensor Name
- 3.2.7.2 Setting Update Rate
- 3.2.7.3 Setting Sensor Vibration Axes
- 3.2.7.4 Setting Temperature Warning and Critical Alarm Thresholds
- 3.2.7.5 Setting Acceleration Warning and Critical Alarm Threshold
- 3.2.7.6 Setting Velocity Warning and Critical Alarm Thresholds
- 3.2.7.7 Setting Sensor Lost Warning
- 3.2.7.8 Setting Temperature Multiplier Factor
- 3.2.7.10 Temperature Calibration
- 4. Maintenance
- 5. Contact Info
WASP™ NEST4 Smart Receiver and Gateway Operations Manual
- 12 -
3.2.2.4.1 RTU Address
Configure the RTU ADDRESS of the receiver by using
the arrow keys to navigate and input the digits.
3.2.2.4.2 BAUD Rate
Configure the BAUD RATE of the receiver to either
9600, 14400, 19200 or 38400 by using the arrows on
the right of the screen and choosing SELECT.
3.2.2.4.3 Stop Bits
Configure the STOP BITS of the receiver to either 1 or
2 by using the arrows on the right of the screen and
choosing SELECT.
3.2.2.5 Set Temperature Unit
You can set the units of temperature to either Celsius
or Fahrenheit by selecting SET THERM UNITS from
the SYSTEM SETTINGS menu. Simply choose the
unit of measurement and press SELECT.
MODBUS SET> ADDRESS
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
BACK
OK
RTU ADDR
001
1 BIT
2 BITS
MODBUS SET> STOP BITS
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
BACK
SELECT
1 BIT
CELSIUS
FAHRENHEIT
TEMPERATURE UNITS
21'C CRI=4 WRN=1 13:46 NOV 24/10
CANCEL
BACK
SELECT
CELSIUS