User`s manual

Please use the MAC address which was printed in the case.

5. Reset Device: Yes / No: Allows you to reset your Wi-Fi Camera and

restart without losing any stored information and settings. To enable this

feature, please select “Yes”, and then click the ”Apply” button.

6. Factory Defaults: Yes / No: Allows you to reset your Wi-Fi Camera and

restart with factory default information and settings. All stored information

and settings will clear. To enable, please select “Yes”, and then click the

“Apply” button. It is the same with the Hardware factory reset.

3. Multiport Defaults: Yes / No: Check “Enable” to allow you to

configure the broadband router from WAN side. To access the setting

page from external side, enter ”http://<WAN IP Address>: 8080” in

the web browser

4.2 PPPoE Setup

IP Camera Setting – PPPoE Setup

1. PPPoE: Enable / Disable: Click “Enable” to enable the PPPoE function.

Then you can connect the IP Camera with an ADSL modem.

2. User Name / Password: Input PPPoE User Name and Password for

automatic login PPPoE then click “Apply” button to update.

3. PPPoE Management: Shows current PPPoE status.

4.3 Dynamic DNS Setup

NOTE: You will have to contact your Internet Service Provider (ISP) to

activate a Dynamic DNS program.

IP Camera Setting – Dynamic DNS Setup

1. Dynamic DNS: Enable / Disable (Not Update): Select “Enable” or

“Disable (Not Update)” to use or not to use the Dynamic DNS

mechanism. The ISP will dynamically allocate an IP address to your

router, if you dial up to Internet by ADSL/Cable modem. If you want the