Installation guide

Final setup 10
Final setup
Name the Playmaker
(MNQCDQSNNOSHLHYDD@RXHCDMSHÖB@SHNMNE/K@XL@JDQHMSGDMDSVNQJDRODBH@KKXHERDUDQ@KOQNCTBSR@QDBNMMDBSDCHMSGDMDSVNQJHSHRQDBNLLDMCDCSN
rename the Playmaker.
> Choose the NETWORK tab to go to the settings menu.
 2DKDBSSGDÖDKCENQProduct name and rename the product of your choice.
E.g. Playmaker_Living Room
> Press the APPLY CHANGES button to save settings.
Software update
(SHRHLONQS@MSSG@SSGD/K@XL@JDQG@RSGDK@SDRSRNESV@QDSNDMRTQDADRSONRRHAKDODQENQL@MBD2NESV@QDTOC@SDQDPTHQDR(MSDQMDSBNMMDBSHNM@MCSG@SSGD
product is wire connected to the network router or switch. Follow the procedure below to check for updates:
> Choose the UPDATE PRODUCT SOFTWARE menu from the setup page.
> Read the CAUTION section before proceeding the update.
> When ready, press the YES button to start the update.
#TQHMFSGDRNESV@QDTOC@SDOQNBDRRSGD/K@XL@JDQLTSDHMCHB@SNQVHKK×@RGQDC6GDM
SGDRNESV@QDTOC@SDHRÖMHRGDCSGDOQNCTBS@TSNL@SHB@KKXQDRS@QSR3GDOQNCTBSHRQD@CXENQ
use, when the network indicator becomes solid white.
Option programming (optional)
The Option programming tells the product how to react on IR-commands from the remote control. The following options are available:
Option: 0 - IR receiver is switched off (no reaction on IR-commands).
4/K@XL@JDQOK@BDCHMSGDR@LDQNNL@RNSGDQ!@MF.KTERDMOQNCTBSR1DLNSDBNLL@MCRLTRSADOQDÖWDCVHSGLINK (e.g. LINK + A.MEM).
5 - The product responds directly to its own codes (A.MEM or A.AUX
).
> Press V + tSNNODMSGDBNMÖFTQ@SHNMLDMT
> Press t until OPTION? is shown in the display and press GO/CENTRE.
> Press t until A.OPT is shown in the display and press the desired digit (option 0/4/5).