Installation manual

6
www.Bosscom.com
Option Programming – fit the tuner to the B&O set up
Option programming is only required for the initial installation of the tuner. The programming itself is
carried out with a Bang & Olufsen remote, pointing directly towards the tuner. The tuner does not need
to be connected to a Bang & Olufsen device, in order to be Option programmed.
The objective is to fit the tuner’s performance to the actual audio set up.
Some installations require the tuner to be operated as an source, whereas in some other
installations only the source might be available.
The option programming procedure is always initiated by pressing the programming switch on the
tuner’s back shortly to make it ready for programming.
The programming sequence itself using the Bang & Olufsen remote, starts off with pressing the
key followed by 3 digits and finished by pressing the key.
All allowed options have a 3 digit configuration.
If the programming procedure is not successful the first time, repeating it is recommended.
Option 106 is programmed as follows:
*1 Using a Beolink 1000, MK I or II has to be replaced by
Allowed options are listed in the tables found in Source & Option Selection below.
LINK