Installation guide

7. Examples of Use
III. Your stereo source - in this example, a BeoSound 3200
®
- is
going to be connected to INPUT 2 of both BOSSCOM Powerlink
switches. You will need a Powerlink Y-cable.
You can also create a trigger level, by connecting the adapter
cable (included) to each INPUT 1 of the BOSSCOM Powerlink
switch, if the audio source provides such, like the LOEWE
®
TV in
the example shown. The voltage must be provided to both
BOSSCOM Powerlink switches with a Y-cable and the short circuit
plug must be connected to the RCA cable with the description
Trigger ON/OFF, of both adapter cables. The advantage of using
the trigger level on INPUT 1 is that is the automatic switch to
INPUT 2 is no longer initiated after a lag of about 1 minute
without audio signal, but immediately when the trigger level is
no longer present - this way you don't need to wait, to be able to
listen to the audio source of INPUT 2.
In the example shown, you can enjoy Dolby Surround Sound for
TV and Speaker-4 sound when listening to the audio system -
and all this completely automatically. You do not need to unlock
the source on the B&O system with the B&O remote control -
you simply turn on the TV and the B&O speakers are turned on
automatically.
The following applies: If both sources are active, INPUT 1 has
priority!