Installation guide

5. Examples of Use

II. Feed-in of LF-Signals (Stereo RCA) to B&O

Systems with

Automatic

Switching (without trigger signal)

B&O

Speakers

B&O

Speakers

e.g. BeoLab 6000

BOSSCOM

Powerlink-Switch

Any stereo source, e.g.

SONOS

Zoneplayer

B&O

System

e.g. BeoSound 9000

Interconnect the BOSSCOM Powerlink-Switch between your

B&O

system and your B&O

speakers. Connect any stereo

source with an RCA cable to INPUT 1 of the BOSSCOM

Powerlink-Switch, via the adapter cable (included).

Once a low-frequency signal is present at INPUT 1, it is

converted to a standard-conforming B&O

Powerlink signal

(including switching signal); otherwise INPUT 2 (Powerlink) is

passed through. CAUTION: If signals are present at both INPUT 1

and INPUT 2, INPUT 1 always has priority!

If the source does not send a signal to INPUT 1 (e.g. it's turned

off, or muted), an intelligent switch provides a delay of about 1

minute - only then will the Powerlink signal be switched off and

the B&O

speakers will go to standby mode, or INPUT 2 will be

passed through (if a signal is present).