Installation guide

4. Examples of Use

I. Converting LF-Signals (Stereo RCA) to Standard-Conforming

B&O

Powerlink Signals

B&O

Speakers

B&O

Speakers

e.g. BeoLab 8000

BOSSCOM

Powerlink-Switch

any stereo source such as

SONOS

Zoneplayer

Connect any stereo source with an RCA cable to INPUT 1 of the

BOSSCOM Powerlink-Switch, via the adapter cable (included)

and use the device as a Powerlink converter.

Once a low-frequency signal is present, a standard-

conforming B&O

Powerlink signal (including switching

signal) is sent.

If the source does not send a signal (e.g. it's turned off, or

muted), an intelligent switch provides a delay of about 1 minute

- only then will the Powerlink signal be switched off and the

B&O

speakers will go into standby mode.

This is necessary for longer pauses in audio books for example

and allows you sufficient time to select the next songs to be

played from your music library.