Specifications

12/16/2002
4
Installation Requirements
The Command Light Shadow must be installed by a designated facility by qualified personnel only.
All safety precautions must be thoroughly understood before installation. Please consult the factory
for additional installation information or assistance.
Refer to the drawing below to determine the location of the required (4) mounting hole locations.
The COMMAND LIGHT SHADOW weighs 70 pounds. Use assistance to lift the light into
position. Drill (4) 5/16” holes to secure lamp to vehicle.
Remove any obstructions below the mounting surface such as headliners. Fasten the light using the
provided hardware. When routing the connecting electric wires use care to avoid sharp bends, hot
surfaces or other hazards to the wire.
Dimensions depicted below are for a standard unit.