® AUDIO SYSTEMS 0X2.600 Two Channel 0X2.800 Power Amplifier 0X4.400 Four Channel Power Amplifier 0X4.600 OXI1.5KM Noblewomen Rawer Amplifier OXYMORA OXFORD OXFORD Congratulations on your purchase of a 3953 ONYX Amplifier. It has been designed, endearing and manufactured to bring you the highest level of performance and quality, and will afford you years of listening pleasure.
FEATURES A 2/| Channel \ Full Range, Class AB A 20 Stereo Ruble A PWM SAMOSET Power Supply A RCA & Speaker Level Inputs A HP &LP Filters \ Bass Boost \ LED Illumination \ Remote Sub woofer Control Channel A Full Range, Class AB A 20 Sterno Stable \ PWM SAMOSET Power Supply A RCA & Speaker Level Inputs Filters A Bass Boost A LED Illumination \ Remote Sub woofer Control FEATURES N 4/3/2 Channel A Full Range, Class A/B \ 20 Stereo Stable A PWM SAMOSET Power Supply RCA & Speaker Lee! Inputs HP & LP Filters Bass
FEATURES Mono block Full Range, Class AB 20 Stable PWM SAMOSET Power Supply RCA & Speaker Laval Input Low Pass Filter Bass Boost LED illumination Remote Sub woofer Control Mono block Full Range, Class A/B 20 Stable PWM SAMOSET Power Supply RCA & Speaker Level Inputs Low Pass Filter Bass Boost LED illumination Remote Sub woofer Control FEATURES Mono block Class D Topology 10 Stable PWM SAMOSET Power Supply RCA inf Out Low Pass Filter Subsonic Filter Bass Boost Phase Control Rama Sub woofer Control Strapping
PRECAUTIONS » This units designed for negative ground Volts(DC) operation only. A Use speakers with an Impedance Ohms (4108 Ohm when used as bridged amplifier) x Avoid installing the unit where: Outwitted ba subject to high temperatures, such as from direct sunlight or hot air from tha heater: Would've exposed to rain or moisture. would've subletting duster dirt. your cars parked in direct sunlight and Theresa considerable rise In temperature Inside the car, allow the unit to cool off before operation.
POWER CONNECTION LEADS POWER HEAD UNIT BATTERY DC 12v To a metal part of car NOTES ON THE POWER SUPPLY: A Connect the +1 2V power input lead only after all other leads have been connected. » Be sure to connect the ground wire of the unit securelytoaproper ground source. A Lose connection may cause a malfunction of the amplifier, REM: The unit is turned on by applying + 12 Volts to this terminal.
HOW TO PROCEED IN CASE OF FAULTS » No Function: » Power Is not connected correctly ( +12V/GND/REM). Before wiring, please pes! off the Insulation of the wire Jacket to ensure that all connections withe metal parts complete. The fuse Is defective-pay attention tithe correct value of anew fuse! No Sound: A Speaker cable or speaker plug are not connected correctly. No Sound / Red LED Protection Shines: A The positive and negative wires of the speaker cable may be shorted.
