Training Guide

BOSS GT-100 Training Guide
3. GOING DEEP
How to Use the LOOPER
1. Press the LOOPER PEDAL for 2 seconds. ON will appear briefly in the
second LCD to confirm the LOOPER is on. The LED on the pedal will
double blink.
2. When you are ready to record, press the LOOPER PEDAL. REC will
appear in the display. The LED on the pedal will blink continuously.
3. When the loop is finished, press the LOOPER PEDAL again. PLAY will
appear in the display, and the loop will play back. The LED on the pedal
will stay on.
4. To overdub, press the LOOPER PEDAL again. DUB will appear in the
display and the LED will blink.
5. To stop using the LOOPER, press and hold the LOOPER PEDAL for two
seconds. END will appear in the display, and the LED will go off.
How to Edit AMPS and EFFECTS
1. Press EFFECTS.
2. Turn KNOB 4 to select an effect. Its parameters will appear in the right
LCD display.
3. Turn the appropriate knob to adjust each parameter.
4. Press EXIT to get back to the main screen.
How to Move AMPS and EFFECTS in the Signal Path
1. Use the above procedures to select an AMP or EFFECT.
2. Turn KNOB 1 to move your selection in the signal path.
3. Press EXIT when you are finished.
How to Use the Tuner
1. Press NUMBER PEDALS 1 and 2 simultaneously. The TUNER will appear
in the left display. The METRONOME will appear in the right.
2. Tune up. The note played will show in the Display. The LCDs in the
display will indicate whether the note is sharp, flat, or in tune.
3. Press NUMBER PEDALS 1 and 2 again or press EXIT to return to play
mode.