Precautions Please read this manual completely and carefully prior to attempting to install your new car video equipment. Install correctly, your new equipment will provide you with years of enjoyable and safe usage. Installation of this equipment in any portion of a vehicle which impairs or distracts the driver is improper and dangerous. We assume no liability whatsoever for failure to follow the proper installation of this products. 1.
Control and Layout for the Monitor Adjust Increase This multipurpose button serves to increase the selected parameter, such as volume, contrast, etc. Menu This button brings up the on-screen menu for adjustment of range of monitor parameters such as, volume, brightness, color, contrast, tint Adjust Decrease This multipurpose button serves to decrease the selected parameter, such as volume, contrast, etc.
Control and Functions of the Remote Control Sleep Setup timer for auto-off V1/V2 Select Video 1 or Video 2 Input Adjust Increase This multipurpose button serve to increase the selected parameter, such as vol, con, col, bri, tint. Power on/off turns on/off the power of the monitor Mute Muting the audio Adjust Up Adjust up to select menu function Adjust Decrease This multipurpose button serves to decrease the selected parameter, such as vol, con, col, bri, tint.
Function Press system button< > on the remote or press manual button< the monitor to call out the function menu.
Games Press < > to enter the games.
Installation Power Cord (Female) Audio input (red) Video input (yellow) Ground (black) DC 12V power input (red) Remote Control Replacing Batteries PULL OUT PUSH 1) Always use new batteries when replacing the old set. 2)Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries. 3)Battery replacement is necessary when remote control acts sporadically or stops operating.
Mounting stand Headrest Housing CAUTION: make sure the screws are not long enough to go through the headrest! If you have any doubts about this type of installation, please consult your local mobile electronics retailer. Steps of Installing Headrest Housing Setup work remove the headrest and set it in an uncluttered work area. Take the appropriate precautions to ensure that it is not damaged during the installation.
Measurements Push on the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut. Cut the Headrest Using an adjustable-depth blade, start your cut 1/4 inch inside one corner and cut diagonally across, stopping 1/4 inch in from the other corner. Repeat the procedure for the other two corners. Remove Foam & Obstructions Carefully peel back the material.
Route the Cable Through the Headrest Run the supplied cable through the opening and out to the bottom of the headrest. If possible, conceal the wires using a shaft covering. Connect the power, ground and video leads to test the MONITOR. Before connecting the monitor, pull the connecting cable assembly through the headrest housing as shown in diagram. Place headrest housing into the opening and secure with correct fasteners.
Operating your system in a safe and legal manner When operating a motor vehicle, it should always be your highest priority to maintain safe driving habits. It is illegal in many areas of most countries to drive with TV or MONITOR turned on, when it is visible to the driver. Please check your local and state laws governing the use of MOBILE ENTERTAINMENT SYSTEM in your area.
