Owner's Manual

Connections
&_CAUTION
It is recommended to have the product
installed by a certified installation
professional.
&_CAUTION
Before installation, or wiring connections,
disconnect the negative (-) battery terminal to
prevent damage to the product, and/or
possible injury.
&_CAUTION
Remote Out is 500 mA max output rating.
If several amplifiers are to be used, it is
recommended to use a relay for the Remote
Out trigger.
Red/Wht ,Rear Camera Power
(+12V, 500 mA)
Red/Violet,Front Camera Power
(+12V, 500 mA)
SWC Input
~ == ~ Orange, Illumination Input (+12V)
Yellow, Constant (+12V)
Violet/Wht, Reverse Signal Input (+12V)
Blue, Antenna Output (+12V, 500 mA Max)
Blue/Wht, Rem. Output(+12v, 500 mA)
28
Unused input/output wires need be
insulated with tape, heat shrink, or crimp
connectors. Never use wire nuts.
Location to plug in
(D Note
A separate interface might be needed for your
vehicle application. It is recommend that you
consult with a professional installer.
(I) Note
When replacing the fuse, always do so with
the same type and value (15 A).