Owner's Manual

OPTIONAL
To remove the distance guide lines:
1. Turn the system OFF before proceeding
2. Cut the white loop wire located at the connection points
(camera end).
3. Insulate the wire, using tape or crimp connectors on both ends.
4. Reconnecting the wire will display the guide lines again.
To invert the camera image:
1. Turn the system OFF before proceeding
2. Cut the blue loop wire located at the connection points (camera end)
3. Insulate the wire, using tape or crimp connectors on both ends.
4. Reconnecting the wire will orient the image back to its original position.
INSTALLATION
1, WIRE CONNECTION
V~DED
~
DC12V ~
Complete all required connections so that all lines are hidden in vehicle.
2, CAMERA INSTALLATION
Camera should be installed in the following configuration:
License Plate Frame Mount - Allgn camera frame with top-set of screw
holes on license plate or license plate frame. Affix camera using license
plate mount screws. See: (diagram 1)
Attention: The camera switch is controlled by reverse gear shift.
(diagram 1)
TROUBLESHOOTING GUIDE
The following checklist might help to solve the problems when using this unit.
Please double check to ensure connection and procedure of operation is done
properly before using checklist.
PROBLEM
NO IMAGE
IMAGE BLURRING
IMAGE SHAKING
IMAGE SLANTED
NOTE :
CAUSE/SOLUTION
Check that power cable is securely connected.
Check to ensure there is a good connection between
video-in and monitor.
Check that REVERSE GEAR is engaged.
Check to ensure correct monitor setup.
Check for water/water stain or dust on camera lens .
Clean camera lens
Check to Insure camera Is mounted and secured tightly.
Adjust
camera mounting bracket
If problems
persist - consult nearest service dealer. DO NOT attempt
to
disassemble or modify unit.