User Guide

Root Folder
Navigate
Press three times to navigate from the root folder.
The root folder name is briefly displayed, after which the first
track or subfolder name is displayed.
AS/PS
Step4 Press to select the desired track within
the folder.
BAND/LOUDNESS
Current Folder
Navigate
Press four times to navigate the current folder.
The current folder name is displayed. After the current folder
name is displayed, the currently playing track name is displayed.
AS/PS
Step4 Press to select the desired track within
the folder.
BAND/LOUDNESS
2
Speakers Connection
This unit can be wired up to 4 speakers.
Make sure that you check all connections before powering up this unit.
Caution:
Do not short speaker wires to chassis ground .
It will cause the unit to be damaged.
Ground Connection
Connect Black Wire to Ground terminal.
Power Connection
First connect the Yellow Wire (w/15Amp fuse block) directly to +12v
constant power. Then connect Red Wire(w/1 Amp fuse block) to ignition output.
Antenna Connection
Insert coaxial connector to antenna socket.
Caution:
If a fuse is blown, only replace it with one of the same rating.
Other wise may cause severe damage . Repeated blown fuse indicates
potential problem(s) exists. A thorough inspection is recommended.
WIRING INSTRUCTION
11
MP3 PLAYER OPERATION
Step2 If a subfolder is selected, the icon will illuminate.
Press " " (or turn rotary encoder to the down) first, to
preview the desired track or subfolder.
NOTE: " " must be pressed first (or turn the rotary encoder
encoder to the down) to continue navigating.
FF
Step3 Press BAND/LOUDNESS to select the desired track or
subfolder. If a subfolder is selected, two "\\" will illuminate.
Press first, then " " (or turn the rotary
encoder to the down) to begin navigating the selected
subfolder. NOTE: " " must be pressed first (or turn the
rotary encoder to the down) to navigate within the subfolder.
BAND/LOUDNESS
Step3 Press to select the desired track or
subfolder. If a subfolder is selected, two "\\" will illuminate in
the LCD. Press AS/PS first, then " " (or turn the rotary
encoder to the down) to begin navigating the selected subfolder.
NOTE: " " must be pressed first (or turn the rotary encoder
to the down) to navigate within the subfolder.
BAND/LOUDNESS
Step2 If a subfolder is selected, the icon will illuminate.
Press " " (or turn the rotary encoder to the down) first,
to preview the desired track or subfolder. NOTE: " " must
be pressed first (or turn the rotary encoder to the down) to
continue navigating.
FF