Technical data

Product Specification
HIF-2121/R5 CAGE CODE: 97896 SCALE: NONE SIZE: A DWG NO: 965-1176-601 REV: D SHEET 45
6.1 Configuration Module
Revision History
Effectivity
Date - Modified By Description of the Updates App. Cfg.
29-NOV-99 Peter Bateman Initial Release and entry into PVCS. -001 -001
24-MAY-00 Susie Wright SCR 4942: General document cleanup. -003 -003
06-JUN-00 – Susie Wright Document only change – Deleted proprietary note from footer. -003 -003
MKVI/MKVIII application uses a configuration module instead of the program pins used by MKV/MKVII EGPWS. This
configuration module contains a minimum of 256 bytes of memory and is capable of transmitting the memory contents to the
EGPWC. The definition of the MKVI/MKVIII feature selections can be found in the MKVI/MKVIII EGPWS Installation
Design Guide. The definition of the data transfer from the configuration module to the MKVI/MKVIII is defined in section
6.10.15. Section 6.10.15 also covers configuration module validity checking and INOP generation that are covered in this
section for the MKVI/MKVIII.
It can be determined if the application is to run as a MKVI or a MKVIII by reading Non-Volatile Memory (NVM).
The configuration module is read by the EGPWS only during power up. The configuration is copied into NVM as long as
there is not a configuration module configuration fault or a configuration module unprogrammed fault.
The configuration module is programmable via an RS232 Interface using a keyboard monitor or user interface tool. The
contents of the configuration module can also be read back by the user through these interfaces.
6.1.1 MKVI EGPWS Feature Selection
Refer to the Installation Design Guide for details on what configuration items options are available for the MKVI EGPWS.
6.1.2 MKVIII EGPWS Feature Selection
Refer to the Installation Design Guide for details on what configuration item options are available for the MKVIII EGPWS.