Specifications Trouble Shooting Before going through the c heck list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power Cause : 12V DC(11V-15V) : Less than 10A : 2ch line out : (1) Frequency Response: 20Hz-20KHz (2) S/N Ratio: 50 dB(JIS) Solution The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to " ACC " The fuse is blown.
General and Radio Controls Setting Mode 7 You can make changes to the system setting in the following area: 5 3 11 1 9 Radio Frequency Range + Enable/Disable AUX In+ Clock Format To enter setting mode, input the following command by pressing remote keys " 8, DOWN DIRECTION KEY, 9, ENTER " The display will show " TEST MOD " breifly to indicate you are in system setting area and then automatically change to Radio Frequency selection mode.
. AUX IN JACK This jack is a convenient way to play music from an MP3 music player such as an ipod through your car audio. Installation support strap Simply connect the headphone output of the MP3 player to this input jack, and press MODE button to select AUX as input source and begin playing music on the MP3 player. Please note: AUX IN Mode can only be selected if it is enabled in the system Settings. If you are having problems with AUX IN mode, please check the setting.
Wiring connection diagram USB/SD Card (MP3 Playback) Controls 1 BLUE (ANT) 0.5A FU SE RED (ACC.
8.RDM (Random Play Mode) Press this button for playback of all the files in the current folder in a random order. “ RDM ON/OFF ” will be displayed. Press again to cancel. 9.SD CARD slot Insert SD card in this slot for playback. Please note icon on panel which shows you how to orient card (angled corner goes to left side of slot). 10. USB port Insert USB drive in this slot for playback. Because the mute time of AF switching or checking time is very short, it is almost inaudible in case of normal program.
Operation of Remote Controller iPod Playback Controls Before removing the iPod from the dock, be sure to pause playback OR use the MODE switch to change to another mode. 1. POWER Use to turn receiver on/off 1 4 5 1 2.In BT mode, when receive a call, the LCD will show the receive phone number, press this button to accept the call. 3. In BT mode, when receive a call, the LCD will show the receive phone number, press this button to reject the call.
3.RDM (Shuffle Mode) Press this button for shuffle playback of all the files in your iPod playlist. 4&5.I<< and >>I (Skip back/skip forward, Fast rewind/fast forward) Press these buttons to skip back or ahead one track. Press and hold for fast rewind or fast forward. iPod compatibility The 758DBI and its specially-designed, included dock adaptors are compatible with a wide range of iPod types.
