00 Contents Screen Adjustment System 19 Before You Start 1 Important Safeguards 4 About this manual 4 Precautions 5 Maintenance 6 Location & function of the controls 7 Remote control 9 Specifications 11 5 Wiring Connections 12 Installing the Unit 13 Detach the Unit 14 Installing the Front Panel 15 Detach the Front Panel 15 Common Operations 3 To Select Source by Menu 16 Reset the Unit 16 Turning the Unit On/Off 16 Volume Control 16 Setting the Sound Characteristics Adjust the Angle 16 EQ Setting 1
Additional Information 11 Common Symptoms There is no power. The disc cannot be loaded. The device does not work correctly (EJECT, LOAD, PLAY) Cause If the power supply is properly connected to the car accessory, switch the ignition key to ON or ACC. The fuse has blown. Replace with same amperatge fuse rate.
Before You Start IMPORTANT SAFEGUARDS About this manual IPOD 10 Eject IPOD File Selector During IPOD mode, press on the monitor to go back to the previous catalog. MENU 1 Be sure to connect the color coded wires according to the diagram. Incorrect connections may cause the unit to malfunction or damage the vehicle, s electrical system. 2 Be sure to connect the speaker (-) wires to the speaker (-) terminal. Never connect the left and right channel speaker cables each other or to the vehicle body.
10 IPOD IPOD Operation During IPOD playback, connect the IPOD wire (5V) to the one in backside of the main unit. When the iPod is loaded, the unit will play a track. To go back to the source status, press iPod to enter into iPod setup: 8/97 DISCo-yeye DISCo-yeye 00:02:47 00:02:47 MENU Back to the previous menu Briefly press to play previous track, press and hold to fast forward. Briefly press to play next track, press and hold to fast rewind.
01 Before You Start Maintenance To Dial by the Unit Replacing the Fuse When cellphone is connected, press23 to input the call number, then press 30 to dial. DIAL OK will appear. When the call is picked up, PICKED UP appears. Make sure the amperage matches the specified value when replacing the fuses. If the fuse is blown, replace it with a new one. Be sure you are using one with the correct rating. If the same problem occurs, it would be subjected to the malfunction.
09 Bluetooth Cellphone Pairing Mode 1. Browse your cellphone menu and find the connectivity or Bluetooth connection section. 2. Select search for a new handsfree device function and allow the phone to find the mobile. (Different cell phones have different bluetooth menus, please refer to your phone manual.) 3. When CAR A/V DEVICE appears, select this item. ( if it can not be connected, please refer to mobile manual, and connect it again.) 4. To input the password, the password is: 1234. 5.
01 Bluetooth Before You Start The Base Bluetooth Operational Interface 09 Using a Bluetooth Wireless Connection Press 28 BT on the remote control or BT on the monitorr to open the bluetooth operational The device can be dialed wirelessly in bluetooth interface: status. Before using the bluetooth function, please turn on your cellphone bluetooth function. 6 1 2 3 SRC/PWR Briefly press to select radio mode or playback mode, press and hold it to turn the unit on or off.
08 01 Before You Start AUX AUX Touch Screen Menu Remote Control Press SRC to switch to the AUX mode: VOL- VOL+ AV SET BLUET SRC In AUX mode, select AV SET: 20 AUDIO ADJUST VIDEO ADJUST VIDEO FORMAT EXIT 30 AV SET For more details to adjust AUDIO, VIDEO and SYSTEM (Auto 1: PAL, NTSC, SECAM), (Auto 2: P-M, P-N). Please refer to pages 19 to 20. To decrease the volume To increase the volume Press it to enter into bluetooth mode.
01 1 SOURCE/PWR 17 (Pause/Play) 2 GOTO (playing time/track) 18 (Stop Playing) 3 BAND/TITLE 4 5 6 19 ST/AUDIO (mono or stereo/language or channel selector) 8 9 (F.R/F.F) 7 4 21 (Previous/Next Track) 5 22 CLEAR 23 0~9 (Number) Buttons (Eject Button) ZOOM (zoom in or zoom out) 27 ENTER (Left/Right/Up/Down ENTER) 4 28 BT (bluetooth mode) Button 5 29 PAIR/VIDEO During bluetooth mode, press it to pair.
07 Tuner MO/ST Selector Number Buttons During radio status, you can press 6 ST button on the remote control to select MONO mode or STEREO mode. During radio status, press Number Buttons to receive the stored stations. During radio status, Number Buttons (from 1 to 6) 23 can help you store your favorite station.
02 Wiring Connection Video Out 2 Video Out 1 REAR RCA Line OUT R/L (black line with red & white head) (Grey line with yellow head) (Grey line with yellow head) (Light Grey line with red & white head) (black line with AUX Video input yellow head) Rear View Camera Input FRONT RCA Line OUT R/L Antenna 87.50MHz 4 5 87.50M 87.50M 90.10M 107.90M 98.10M 106.10M 7 8 9 10 1 5 3 1 Band Indicator Shows which band the radio is tuned to.
06 CD/MP3/SD/USB Pause the Playback Program Playing During CD/MP3/SD/USB playback, Press to switch between play and pause. During CD mode, press 13 PROG, the TFT displays the program menu. Press NUMBER BUTTONS to select the track Number and then press 27 to move the cursor to START. Press ENTER to start program playing. Move the cursor to EXIT and press ENTER to exit the program playing. Move the cursor to and press ENTER to the previous page; move the cursor to and press ENTER to the next page.
02 Installing the unit Selecting Tracks During MP3/SD/USB playback, press 21 to play previous track, press 21 to play next track. During CD playback, first press 21 to return to the beginning of the current track, press 21 again within 3 seconds to play previous track , press 21 to play next track . Installation Method 2 Installation using the screw holes at the sides of the unit.
06 CD/MP3/SD/USB CD/MP3/SD/USB Setup Track Region: During CD playback, touching the screen shows the following menu: Track region 01:18 Press this region and the screen shows the following menu: number keys appears, touch the number to select tracks. Touch the " X " to exit this menu. MP3 Track 03/16 02 Installation Install the Front Panel Detach the Front Panel Put notch A (shown as picture) onto shaft B .And then slightly press into the right side.
Common Operations 03 To Select Source by Menu In any mode, press SRC on the monitor, the following menu will appear: Note: * Pressing PWR button on the main unit also performs the same function. Press 14 VOL+ button to increase the sound level and press 14 VOL- button to decrease the sound level. Note: * Rotating VOL+/- on the main unit or VOL+/on the monitor performs the same function.
05 Common Operations DISC/VCD/MP4 ---Preferences page-DISC Menu Example showing how to set DISC Menu Language: (Press (Press , --Preference Page-TV Type Audio Subtitle DISC Menu Parental Password Default Auto Eng Eng Eng Go To Preference Page or , then press ENTER) --Preference Page-TV Type Audio Subtitle DISC Menu Parental Password Default Auto Eng Eng Eng Preferred Menu Language English French Spanish Chinese Japanese Korean Russian Others Turning Loudness On/Off Mute Function Press and ho
04 Main Menu Setup 06 CD/MP3/SD/USB Main Menu 1.Video Adjustment After selecting VIDEO, the sub menu will appear as follows: Subtitle Example showing how to set subtitle language: (Press (Press --Preference Page-VIDEO AUDIO SOURCE SYSTEM TV Type Audio Subtitle DISC Menu Parental Password Default EXIT This menu includes VIDEO, AUDIO, SOURCE, SYSTEM, EXIT. Press them on the monitor to set the desired status.
05 DISC/VCD/MP4 ---Preference page--TV Type 2.Audio Adjustment 3.
04 Clock System --General Setup Page-- Reverse Pola Captions CLOCKSYS SYS CLOCK KEY BEEP KEY BEEP 05 DISC/VCD/MP4 Main Menu LAMP SEL Example showing how to set captions on/off: (Press (Press LAMP SEL MONIFLEX FLEX MONI , EXIT EXIT Press CLOCK SYSTEM on the monitor to set 12 HOUR or 24 HOUR in this menu. Key Beep EXIT Setting REVERSE POLA in this menu. If the signal is +12V , please press BATTERY in the monitor. If the signal is 0V, please press GROUND.
05 DISC/VCD/MP4 --General Setup Page-- TV Display (Press , , then press ENTER) TV Display Angle Mark OSD Lang Captions Screen Saver Wide On Eng Off On Go To General Setup Page or LOCAL AREA --General Setup Page-- --General Setup Page-TV Display Angle Mark OSD Lang Captions Screen Saver RT Scroll Local Area Example showing how to set TV Display mode: (Press 05 Main Menu Wide On Eng Off On LOCAL EUROPE SLOW NORMAL FAST U.S.
05 Adjust Screen CLOCK SYS KEY BEEP MONI FLEX EXIT SAVE (Picture 1) Press ADJ SCREEN to display the above menu. Press the square button at the top left ,then the button will move to place , press it at place , it will move to place , then place , press SAVE.
05 DISC/VCD/MP4 Changing the viewing angle (Multi-angle) With DISCs featuring multi-angle (scenes shot from multiple angles) recordings, you can press 7 ANGLE to switch among viewing angles during playback. Selection options switch as follows: ANGLE 1 ANGLE 2 ANGLE 3...... Notes: * This function is operated by using the remote control. * This function only operates with DISCs featuring multi-angle recordings. * The mark on a DISC's package indic3 ates it features multi-angle scenes.
05 DISC/VCD/MP4 Playing Tracks at Random During DISC/VCD/MP4 playback, press 16 RDM button on the remote control to play any track at random under the directory which you select. Press it again to return to normal playing. Note: Note: * The function can be operated by selecting the DISC MENU SETUP. During VCD status, press OSD button the display shows: Single elapsed Display off Slow motion playback During DISC mode, press to slow play.
