0814
INSTRUCTIONS INSTRUCTIONS Panel Introduction CONTENTS Panel Introduction Basic Function Remote Control Operation Turn on/off Host Access main interface USB/SD Card Operation Radio Operation Disc Operation Play/Eject Disc DVD/VCD Disc Playback CD Disc Playback 02 03 05 07 07 07 08 09 09 09 09 09 09 11 11 11 11 MP3/WMA Format Disc Playback Touch Menu Function ST.
BASIC FUNCTION INSTRUCTIONS 1. /OPEN Button Press the button to open / close the screen. Press this button for short moment to turn on power, and long press it to turn off power. 2. MODE Button When the unit is power on, Repeat press this button can switch to different function mode as following picture. Note: When the device without connecting to USB、SD or DVD no disc inside, the system will automatically skip these related working mode. 12.
INSTRUCTIONS Remote Control Operation 3. SOURCE Button Press this button to change mode. 28 4. EQ Button Press this button to choose POP、ROCK、 CLASSIC、EQ off. AMS / RPT MUTE TITLE SOURCE AUDIO EQ GO TO SEEK+ / SEEK- SUBTITLE VOL+ / VOL- PBC SEL UP / DOWN / L / R ENTER LOUD SLOW BAND / P / N ANGLE LOC / RDM SETUP STOP OSD PLAY / PAUSE ZOOM ST / PROG MENU 0-10+ DSP 2. MUTE Button Press once to turn off audio output, press again to resume volume level. 24.
Turn on/off Radio Operation When the ignition switch is put in ACC or ON position, Press [ ] button on the front panel to turn on the unit. After the host starts, hold [ ] button for 3 seconds, the host will turn off. 1. Enter/exit Touch [Radio] icon in the main interface to enter into the radio interface. Touch icon to return to main interface, and then touch other function icons so as to exit radio mode.
Disc Operation INSTRUCTIONS 1. Play/eject disc Play disc Insert the disc into the disc slot with the printing surface up, system will detect the disc and automatically take it in to read and play. Eject disc (1) Click button on the panel to eject the disc. (2) If a disc has not been took away 15 seconds after it is ejected, system will automatically take in the disc but not play. Do not insert two discs or more.
ST. Wheel setting Other Operation 1. Click on the [ ] icon in the main interface into the SWC. settings interface. 2. The original vehicle to the control line positive, negative with the machine control line in the positive and negative connection. 3. Click the SWC buttons will appear corresponding operating tips, and fundamental operation prompts the SWC feature set. 4. Set function to save the settings and click the Confirm icon to confirm. Note: To modify function settings, repeat procedures 3~4.
Access setup interface INSTRUCTIONS Version Click [Setting] icon on main interface to access setup interface. Touch the icon [ ]in setting interface to enter the interface below to check the software version number of DISC/MCU/TFT (The version information is displayed please prevail in kind.
Touch screen Calibration WIRING DIAGRAM Please follow the below instructions to calibrate when there is no touch or touch is not accurate. Step 1: Press the mode button in the unit to switch to DVD mode. Step 2: Insert a DVD disc, after DVD is loaded, press the stop button “ ” as show in picture (1). in the remote short, the unit will display as show in picture (2). Picture ( 1 ) Step 3: Press “ picture (4).
INSTRUCTIONS INSTRUCTIONS SPECIFICATIONS ACCESSORY Power supply DC 12V Power range 10.8-16.0V DC Max Current Consumption 15A Ground system Negative ground Power Output 85 WattsX4 Channels FM tuner US frequency range 87.5-107.9MHz European frequency range 87.
