Specifications

8
6. PATTERN Section
To play back the currently selected pattern:
1. Click the PLAY button; playback of the currently selected pattern repeats.
2. Click the STOP button to stop playback.
Clicking the STOP button a second time returns the playback-start position to the beginning of either
the leftmost measure currently visible, or the measure immediately following the leftmost one.
Clicking the STOP button yet again returns the playback-start position to the beginning of the pattern.
* In the case of the figure below, the leftmost measure currently visible refers to the area inside the red box.
* In the figure below, the leftmost measure currently visible is the second measure.
・If you want to change the tempo during playback, adjust this with the TEMPO knob in the
COMMON section.
・If the sound breaks up during playback, try changing the output destination using “Setup” -
“Set Up Audio Device” (Windows version only).
To input drum sounds and edit patterns:
In the Pattern View, the vertical axis indicates the tone (drum sound) used for input, and the horizontal axis
indicates the entry location.
Clicking on a square specifies the input timing for the drum sound that is input.
Example: Adding the CROSS STICK sound at the third beat of the first measure and the TOM1 sound at the
first beat of the second measure
1. Double-click on the square, then input the CROSS STICK sound at the third beat of the first measure.
2. Without making any other changes, use the arrow keys on the computer to move to the TOM1
location at the first beat of the second measure, then use the Enter key to apply it.
You can input the drum sound by right-clicking and selecting “Add” from the menu that appears.