Specifications

4
2. Connecting / Disconnecting the BR-800
Do not disconnect the USB cable connected to the BR-800 while BR-800 Rhythm Editor is
running.
Doing so may cause malfunction or loss of data.
1. Turn on the power to the BR-800.
2. Connect the BR-800 and your computer with a USB cable according to the instructions
in the BR-800 Owner’s Manual, then select [MENU] - [USB] - [RHYTHM EDITOR].
3. Press the BR-800’s [ENTER] button.
4. (Mac version only)
Open
“System Preferences” of Mac OS and click [Sound], then select “BR-800 44.1kHz”
for each of the following settings:
•“Play sound effects through” under the “Sound Effects” tab
•“Select a device for sound output” under the “Output” tab
5. Start up BR-800 Rhythm Editor.
The BR-800 and BR-800 Rhythm Editor are connected automatically.
6. (Windows version only)
Click
“Setup” - “Set Up Audio Device,” and select “OUT (BR-800)” in “Output Device.”
When the BR-800 and computer are properly connected, the CONNECT button at the upper part of
the screen turn into [DISCONNECT]. If the BR-800 and computer are not properly connected
(if [CONNECT] continues to be shown), click [CONNECT] manually to connect the devices.
Once execute DISCONNECT operation, the connection cannot be made again by clicking the
CONNECT button.
Either disconnect and then reconnect the USB cable, or re-enter the USB RHYTHM EDITOR
mode on the BR-800.
Severing the connection to the BR-800 causes any data not yet saved on the BR-800 to be discarded.
1. Click the DISCONNECT button at the upper part of the screen.
* A confirmation message is displayed; click [OK].
2. Press the BR-800’s [EXIT] button.
* When the message “Are you sure?” appears on the BR-800, press the [ENTER] button.
3. The connection between the BR-800 and BR-800 Rhythm Editor is terminated.
* After the connection is terminated, the DISCONNECT button turn into [CONNECT].
2. Connecting / Disconnecting the BR-800
2-1. Connecting with the BR-800
2-2. Disconnecting the BR-800