Specifications

16
7. ARRANGEMENT Section
You can drag and drop a pattern to directly insert it at the desired point in Arrangement View.
You cannot use a pattern in an arrangement before the pattern is saved.
1
Select a pattern in the PATTERN section.
The content of the currently selected pattern is shown in Pattern View.
2
Click the DRAG symbol, and then drag and drop the pattern on the desired point in Arrangement View.
The currently selected pattern is then inserted.
When the Bank field in the PATTERN section is not in EDIT display, the DRAG symbol is enabled.
When the Bank field in the PATTERN section is in EDIT display, inserting patterns into Arrangement
View is not possible. The DRAG symbol is disabled.
You cannot use a pattern in an arrangement before the pattern is saved.
1
Right-click on the desired Step area in Arrangement View.
2
Select “Insert” from the menu that appears.
A Step area with the same content is added immediately before the selected Step area.
* The length of the Step added by this procedure must be one measure.
You can also insert the pattern by pressing the Insert key (Windows version only).
3
Change the pattern number and tempo or step length as needed.
* For more detailed information, refer to the relevant section.
When you want to stop the performance for a specific measure (that’s to say, when you want to input
a rest measure), insert a BREAK.
The length of the last Step within an arrangement is equal to the number of measures in the pattern used.
7-2. Using Drag & Drop to Insert Patterns
7-3. Adding Step Areas and Inserting Patterns in Them
Changing the Pattern Number 7-4. Changing the Pattern To Be Used (p. 17)
Changing the Tempo 7-9. Setting the Tempo for Individual Steps (p. 19)
Changing the Length of a Step 7-7. Changing the Length of a Step (p. 18)