Specifications

11
6. PATTERN Section
Use this procedure to create patterns, entering drum sounds in individual squares in Pattern View and
specifying the timing for the input drum sounds.
1
Select the drum kit to be input.
2
Set the number of measures.
Click on the LENGTH field, then use the computer’s keyboard to directly type in a value from 1 to 999.
3
Set the time signature.
Select the pattern’s time signature with the TIME SIGNATURE Selection button.
4
Set the resolution.
Adjust the Zoom bar to set the resolution.
5
Input a drum sound.
You cannot input or delete drum sounds for squares in which appears.
Adjusting the Zoom bar to make the resolution finer makes the displayed drum sound change to ,
enabling you to adjust the velocity value or delete the drum sound.
6
Adjust the velocity.
Adjust the velocity (the loudness of the sound) for the input drum sound in the VELOCITY field.
You can also individually adjust the velocity value for each drum sound you input by using the
computer’s keyboard to directly type in a value from 1 to 127.
For more information about adjusting velocity values, refer to “To adjust the velocity of the drum
sound input in the currently selected square” (p. 9).
7
Repeat Steps 5 and 6 as needed.
You can delete unneeded drum sounds.
For more detailed information, see “To delete a drum sound that has been input” (p. 9)
You can also change the number of measures, the time value, the resolution, and the velocity value
during pattern playback.
6-2. Entering Drum Sounds and Creating Patterns