Specifications

2006 F-250/F-350
Super Duty Pickups
53
F-250/F-350 SD PICKUPS
July 2005
F-250/F-350 SD Pickups
Snowplow Installation/Minimum Required and Recommended Equipment cont’d
Electrical Connections
Installation of any inductive load devices (i.e., electric motors, electric clutches for clutch pumps, etc.) MUST NOT be
connected to OEM wiring or fuse panels. Power for such devices should be taken directly from the battery or starter
motor relay power terminal. Control of these devices should be achieved via relays. No direct current path should
exist between OEM wiring and the installed load that is not filtered by the battery. These recommendations are
intended to reduce or eliminate any induced reverse voltage into the OEM circuitry.
Warranty
The Normal Ford New Vehicle Limited Warranty applies to vehicles with snowplows installed in accordance with
these guidelines. Consult your Ford dealer or the Owner’s Guide for any further questions.
BlockerBeam
A metal crossmember is included below the front bumper on Super Duty vehicles called a “BlockerBeam.”
Warning: Removing the BlockerBeam without installing snowplow attachment hardware may effect airbag
deployment in a crash. Do not operate the truck unless either the BlockerBeam or snowplow attachment hardware
is installed on the vehicle.
Special Applications cont’d
06_F-250F-350 PU.fm Page 53 Thursday, September 1, 2005 7:59 AM