Thank you for choosing our product! Please read the instructions carefully so you will know how to operate your product properly. If there are any technical questions, please contact: Customer care: (805) 751-4853 & Live chat Online support: www.bossaudio.com/support IMPORTANT Please enter below the Serial No. which is located on the exterior of the product. Retain this information for future reference. Model No. Serial No.
Table of Contents Introduction ......................................................................................................................................... 1 Package Contents .............................................................................................................................. 1 Important ............................................................................................................................................ 2 Mounting .................................
Important Read and understand all instructions before you use your product. If you do not follow the instructions in this manual, we are not responsible for any resulting personal injury or damage to property. This will also void the warranty. Important Safety Precautions • Be sure to observe the following guidelines: - Do not increase speaker volume so high that you cannot hear what is around you. - Use caution or temporarily discontinue use in potentially hazardous situations.
Mounting See the section “Installation Precautions” on page 2. Keep connection cables away from any pinch points, moving parts, or any hot exhausts. Do not install the speakers where they may obstruct the rider’s view or inhibit any safety features on the vehicle (e.g. lights, horns, brake levers, etc.). Before you drill any holes, investigate your vehicle’s layout very carefully. Take special care when you work near the fuel tank, fuel lines, hydraulic lines and electrical wiring.
Mounting the amplifier You can secure the power amplifier in your vehicle using the supplied screws. 1. Find a suitable location in the vehicle to mount the amplifier. Make sure there is sufficient air circulation around the intended mounting location. 2. Secure the amplifier as follows: a. Use the four screw holes on the amplifier to mark the mounting holes on the mounting surface. b. Drill the mounting holes in the mounting surface. c.
Power Source Connection Option 1: Direct connection to vehicle battery Note: Direct connection to vehicle battery consumes power. Always use the inline power/volume knob to cut the battery power when the speakers are not used. 1. Using the supplied power cable harness, connect the black cable (labeled “GROUND” ) to the vehicle’s metal frame or to the negative battery terminal and the red cable (labeled “+12V”) to the positive battery terminal. 2.
A : Connect the power cable harness. See the section “Power Source Connection” for complete power connection instructions. B : Connect the speaker cable harnesses. C : Connect your mobile phone or MP3 player for audio input to the speakers, using an audio cable (e.g. 3.5mm audio cable or 3.5mm audio input adapter). Bluetooth Streaming Before you can stream music from your mobile device (iOS device or Android device) to this product through Bluetooth, pair this product with your mobile device. 1.
3. Play audio files on your audio device. Audio from the mobile phone will be played on this product. Rotate the inline power/volume knob to adjust volume. For best audio performance, set the volume of the mobile device to maximum. If there is distortion heard, turn down the connected device’s volume a little. Operating this product consumes the vehicle battery. To avoid battery exhaustion, be sure to run the vehicle engine when operating the product.
Specifications Bluetooth Bluetooth version ......................................... 5.0 / EDR Bluetooth profiles ......................................... A2DP Bluetooth frequency..................................... 2402 – 2480 MHz Transmission power..................................... <4 dBm Transmission distance ................................. up to 33 ft /10 m (line of sight) Audio Speaker driver ............................................. 3” (76 mm) Speaker impedance.............................
