2, {1} In the Box 00 Glass Smart Lock Lock Adapters™3 AA Batteries Batsman Aegis WI-Fi Gateway*1 Adhesive Strip*l {2} Tools you will ends: Phillips Screwdriver
3. installation Aegis {1} Fix the deadbolt in place Use the adhesive strip in the box to fix the exterior [outdoor] part of the deadbolt, in order to prevent it from falling when the thumb tum is f removed. {2} Remove the thumb tum Make sure that the deadbolt is in locked position. Unscrew both screws and remove the thumbprint from the deadbolt. Keep the screws handy far the nest step.
{3} Remove the base plate Open the latches To remove the base plate {4} Place the base plate over the deadbolt Insert the two screws into the screw holes from the front of the base plate. Match both screws to the screw holes on the deadbolt. Please make sure that the base plate's back side is against the door, Le. the bottom part of the base plate should be touching the door.
{5} Mount the base plate Adjust the base plate so that the til piece goes through its center hole. Tighten the screws to fix the base plate on the door. Please do not over tighten the screws as it may damage the door. {5} Select the correct adapter Select the correct adapter based on your dead bolt's tailpiece. ihe adapter fits the tailpiece but does not tin Aegis's miter, Alp the adapter and try again. Place the adapter on the tailpiece.
{1} Check the deadbolt's locking direction Looking out from Inside of the door, 1 the bolt Is at the left side of the door, than it locks counterclockwise; ¥ the bolt is at the right side, then it {irks clockwise. Counterclockwise Clockwise {8} Turn Aegis to the locked position If the deadbolt locks counterclockwise, gently turn Aegis counterclockwise Hl the end; if the deadbolt locks clockwise, gently tum Aegis clockwise tl the end. Note: Stop Turning once you feel a strong friction turning further.
5 Install Aegis Make sure that the door remains locked. Open both latches on the back of Aegis, and mount Aegis on the base plate, Make sure that the adapter fits in the motor, and there Is no gap between the base plate and Aegis. Finally, close the latches so that Aegis is secured on the base plate.
{11) Set up Aegis In the Boa ma app Download the Zosma app on your phone. Log in or create a new Zosma account, On the home screen, tap the "+ button at the top right comer, and select “Aegis” from the Ist. Follow the instructions in the app to complete the cutup process.
3. installation Zosma Aegis WI-Fi Gateway {1} Follow instructions in the app to set up your Aegis door lock {2) Plug in the Gateway to an outlet {8) Long-press the Pairing button on Aegis Gateway.
Quick Start Guide 1. Follow the Installation Instruction to install Aegis on your door. 2. Download "ZOSMA" from Google Play or App Store. 3.Login to ZOSMA or create a new account. 4. Tap the "+ button at the top right corner of the home screen. 5. Select “Aegis” and follow the instructions on screen to complete the setup. Customer Service &, & L800) 976.0881 £2 www, bosmasmarthome.com + The quick start guide is subject to change without notice, please find the latest version on www bosmasmarthome.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FOC Rules, Operation is subject 0 the following two conditions: {1} this device may not cause harmful interference, and [2] this device must accept any interference received, including interference that may cause undesired operation.
