User's Manual

9
SETUP
E
ng
li
s
h
D
eu
t
sc
h
F
ran
ç
a
i
s
D
ans
k
E
spa
ñ
o
l
It
a
li
ano
S
vens
k
a
N
e
d
er
l
an
d
s
D
ans
k
It
a
li
ano
S
vens
k
a
D
eu
t
sc
h
N
e
d
er
l
an
d
s
E
ng
li
s
h
F
ran
ç
a
i
s
E
spa
ñ
o
l
The transmitter Channel button
You can use the Channel button to narrow the selection of frequencies the transmitter uses.
At the factory, the transmitter is set for use of any frequency. This may cause noticeable
performance problems (slow or intermittent data transmissions) for a nearby wireless (WiFi)
network. To eliminate this problem, you can use the Channel button to reserve one
channel for use by your Wifi network.
To reserve a channel for use by your WiFi network
1. In the grouping below, locate the channel used by your nearby WiFi network :
NO WIFI NETWORK...6...11...1...2...3...4...5...7...8...9...10.
2. Count the number of forward moves it takes from the NO WIFI NETWORK setting to
reach the Wifi network channel. For example, if your Wife network uses channel 3, you
need to move forward 5 times to reserve channel 3 for Wifi network use only.
3. Press the Channel button for less than 3 seconds to move forward once. Repeat as many
times as needed to reach the channel you want to reserve. The Status LED will blink red
each time you do.
To start over, press and hold the Channel button for more than 3 seconds to return to All. The
Status LED blinks red three times to confirm that move.
If the WiFi network channel is unknown to you, use the Channel button to switch off one
channel at a time. Test the WiFi network to see which setting gives you the best effect.
Your Bose
®
link expansion room remote control
•Room code
If you have more than one LIFESTYLE
®
system expansion room, make sure the remote
used in each one has a unique room code.
•House code
The house code setting on the remote must match the setting on your LIFESTYLE
®
system.
It may not match if you changed the system house code due to interference with another
system.
For information on these house code and room code settings and how to change them, refer
to the owner’s guide that came with your remote.
Note: Setup codes for the transmitter and receiver, which must be identical to each other, do
NOT need to match House codes on the remote or LIFESTYLE
®
system.
Your Bose link expansion room product
•Room code
Make sure the system, amplifier, or powered speaker room code setting matches that of
the remote you are using in the expansion room.
For information on room code settings and how to change them, refer to the owner’s guide
that came with your Bose link product.
Enjoy your wireless entertainment
With the settings confirmed, your Bose link Bose® link AL8 Homewide Wireless Audio Link is
ready for use.
To explore and enjoy all of the capabilities provided by your expansion products, refer to the
owner’s guide provided with each product.