Owner manual

3
SETTING UP YOUR WAVE
®
MUSIC SYSTEM
TAB 5TAB 4TAB 6TAB 8TAB 7English TAB 3TAB 2
Unpacking
Please check the shipping carton for the following items:
Wave
®
music system
Power cable
Demonstration CD
Remote control
(battery pre-installed)
SoundLink
TM
adapter SoundLink
TM
USB key
Selecting a location
• For best performance, place your Wave
®
music system
across the room from where you will be listening.
• Place it on a table or other flat surface and position it
within
2 feet (.7 m) of a wall but away from a corner.
• Place the adapter in a convenient location. It does not
need to
be within view.
If the adapter is to the left of the system (as you face
it), be sure the two are at least 2 in. (5 cm) apart to
eliminate any interference with AM reception.
CAUTIONS:
• DO NOT place your Wave
®
music system on a metal surface,
which could interfere with AM reception.
• Avoid placing it on a heat-sensitive surface. Like all electrical
equipment, it generates some heat.
• Avoid placing it in a damp location or any other place where
moisture can
get inside.
• Placing the adapter close to a TV, refrigerator, fluorescent
lamps, halo
gen lamps, dimmer switches, or other electronic
equipment can cause electrical noise interference.
Connecting the Wave
®
music system
1. Insert the flat plug on the power cable into the
connector labeled AC POWER on t
he rear panel
of your Wave
®
music system.
2. Insert the plug at the other end of the cable into
an el
ectrical outlet.
3. Unwind and straighten the power cable to ensure
the best FM reception. Your Wave
®
music system
uses the power cord as an FM antenna.
4. Plug the SoundLink
TM
adapter cable (with the words
Bose
®
link facing up) into the connector labeled
Bose link on the rear of the W
ave
®
music system
Bose link
cable
Bose link
connector
.
Note: You can find information on using the adapter in
“Listening to music on your computer” on page 8.
00_SoundLink_book.book Page 3 Tuesday, July 7, 2009 9:58 AM