Specifications

Setup

Setting up additional power stands for more bass output

If you need more bass output than a single power stand with two bass modules can deliver,

there is a solution. You can purchase an additional power stand (without loudspeakers) and

use its three amplifier channels to drive up to six more bass modules. The second power

stand operates as a slave to your primary power stand.

There are three bass configurations:

•Full bass

• Distributed bass

•Shared bass

Note: Do not insert a Cylindrical Radiator™ loudspeaker into a power stand when it is being

used as a stand-alone amplifier. This automatically switches the outputs of the amplifiers from the

control panel jacks (Amp 1 OUT, Amp 2 OUT, and Amp 3 OUT) to the loudspeakers.

Full bass setup

A full bass configuration (Figure 7) consists of two bass modules connected to a primary

(“master”) power stand and six bass modules connected to a “slave” power stand which is

driven by the “master” power stand. In a full bass configuration, all eight bass modules are

driven by the same level and equalization settings. Because this configuration is abnormally

bass-heavy, you may need to adjust the equalization on the remote control to suit your artis

tic preference.

Figure 7

Full bass block diagram

1. Set up your primary power stand using two bass modules. See “Product assembly” on

page 9 and “Connecting a bass module to the power stand (optional)” on page 11.

2. Connect all six additional bass modules to the second power stand. Connect two bass

modules to the Bass/Amp 3 OUT jack. Connect two bass modules to Amp 1 OUT and

two more to Amp 2 OUT. See

“Connecting two bass modules” on page 12.

3. Group all bass modules together. They can be stacked as shown in Figure 6.

4. Using a typical ¼-inch phone plug connection cable (guitar cable), connect the Bass

Line OUT jack on your primary power stand to the All Amps IN jack on the second

power stand.

Primary power

stand

Slave power

stand

Bass Line OUT

All Amps IN

Amp 2 OUT

Amp 1 OUT

Bass/Amp 3 OUT

Bass modules