User guide

Bose
®
ControlSpace
™
Designer
™
Software User Guide
50 Chapter 3: Build a ControlSpace ESP-88 system
DSP Resources
As you design your ControlSpace ESP-88 system, use the DSP
Resources window to monitor the signal processing and delay usage for
the ESP-88. To open the DSP Resources window, first select the ESP-88
window, then choose Tools > DSP Resources, or press the DSP
Resources button:
Figure 3.23 - DSP Resources
The DSP Resources window shows the percent capacity used for signal
processing (DSP) and delay in the selected ESP-88.
Connecting to the ControlSpace ESP-88 system
After you have finished your system design, you need to connect to the
ControlSpace ESP-88 system to upload the design into the ESP-88(s). If
you have not already done so, you must first make the proper hardware
connections to establish the local network for your ControlSpace ESP-88
system. For more information on hardware connections and network
settings, see Chapter 1: Configure the ControlSpace Designer network.
There are two methods by which you can go on-line: download and
upload. Most often, you will make changes to, or create a design in
ControlSpace Designer software, and then upload the design to the ESP-
88. Alternately, you can use the download option as a way to see the
currently running configuration in a ControlSpace ESP-88 system.