User guide

Bose
®
ControlSpace
™
Designer
™
Software User Guide
10 Chapter 1: Configure the ControlSpace Designer network
2. Launch ControlSpace Designer software and choose System >
Network Setup to open the Network Setup window.
Figure 1.11 - Network Setup window
3. Select the CC-64 and press the Change to... button to change
the IP address of the connected CC-64. The Address setting
window opens. Each CC-64 must have a unique IP address in
your local network. You must change the IP address of this first
CC-64 so there are no conflicts when you connect the next CC-64
(which also has a default IP address of 192.168.0.176).
Note: When using two CC-64s, you must change the IP address of the
first CC-64 that you connect so that there are no conflicts when you
connect the next CC-64 (each CC-64 is shipped with the same
default IP address).