User guide

Bose
®
ControlSpace
™
Designer
™
Software User Guide
126 Chapter 6: Program GPI/O and Serial Input/Output
Set the state of a specific GPO channel by clicking on the ON/OFF
button.
Figure 6.13 - Click a button to set the GPO state
Programming GPO
The process for programming a GPO is different than that of a GPI. There
are two ways to program a GPO. The first method is to use the Project
Directory. After setting the state of the GPO to ON or OFF, find the GPO in
the Project Directory window, and drag it into a parameter set, or timer.
When the parameter set is invoked or the timer expires, the GPO will
change to the programmed state (ON or OFF).
Figure 6.14 - Drag a GPO from the Project Directory to a parameter set or timer