Technical information

12
G
ETTING YOUR HEADSET READY FOR USE
Figure 7
Positioning the mic cable
assembly on the preferred
earcup
Connector
pins
Access
cover
Cable
assembly
Connector
pins
L for left
4. Press the assembly onto the connector pins until it is fully
engaged and the cable assembly is flush with the earcup.
CAUTION:
Do not apply excessive force, which may result in earcup dam-
age.
5. With the screw threads properly aligned, tighten the screws.
6. Rotate the microphone boom
into position so it will be near your
mouth when you put on the headset. The label should be facing
your lips.
7. Attach the access cover to the connector panel on the earcup
t
hat does not have the boom mic attached. Align the screws and
tighten them to secure the cover.
• If you moved the boom mic from one earcup to the other, reuse
the
access cover you removed earlier.
CAUTION:
Be sure to try the headset and test its operation before flight.
Clothing clip
Use the clothing clip (Figure 8) for attaching the control module to
your clothing, a safety harness, or an aircraft door pocket. Pressing
on
the end of the clip allows you to reposition it along the cable.
Figure 8
Moving the clothing clip
along the cable
Press to release
CAUTION: Do not attempt to clip onto surfaces that are more than
1
/
4
-inch thick.
00_AM270261-01_HeadsetXII.book Page 12 Tuesday, August 11, 2009 2:27 PM