Technical information

26
General Care and Maintenance
Replacing the battery
Replace the battery as follows (see Figure 13):
1. Turn the ON/OFF switch to OFF.
2. Slide the battery cover away from the control module, using
the finger indent.
3. Remove the old battery.
4. Ensure that both the battery and the receptacle contacts
are clean.
5. Install a 9V alkaline battery. (The control module is
mechanically keyed to ensure proper polarity at
installation.)
6. Replace the battery cover.
Figure 13
Replacing the battery
Replacing the wind screen
Replace the wind screen as follows (see Figure 12):
1. Remove the attaching band by rolling away from the tip of
the microphone.
2. Gently pull the wind screen from the microphone.
3. Remove the attaching band. Cut the band with small
clippers if necessary.
4. Slide-on the replacement wind screen and ensure that it fits
securely over the microphone.
5. Roll a new attaching band over the installed windscreen to
the proper position.
Figure 12
Replacing the wind screen
1 2 3 4 5
finger
indent