DVD Home Entertainment Systems Installation Guide

12
System Installation Instructions
Making a plug-in cable speaker connection
In a plug-in cable connection (Figure 8), the positive and negative wires are oriented to ensure
proper polarity.
Figure 8
A plug-in cable type
speaker
1. Match the correct cable to the corresponding speaker location. Front speaker cables
have blue RCA connectors at one end, with L (left), R (right), or C (center) molded into
both the RCA connectors and the speaker connectors at the other end. Surround
speaker cables have orange RCA connectors at one end, with L (left) or R (right) molded
into both the RCA connectors and the speaker connectors at the other end.
2. Insert the speaker connector of each cable fully into the jack on the rear of each of the
five speakers. Match the ridge of the connector to the notch at the top of the jack.
3. Connect each cable to the corresponding jack on the Acoustimass
®
module (Figure 9).
Plug the blue connectors into the matching left front, center, and right front jacks. Plug
the orange connectors into the matching left surround and right surround jacks.
Figure 9
Speaker connections to the
Acoustimass module
3
3
OUTPUTS TO
CUBE SPEAKERS
AUDIO
INPUT
POWER
FRONT SURROUND
100-120/200-240V AC
50/60 Hz
350W MAX.
L
C
R
L
R
Front speakers
Left Center Right
Surround speakers
Left Right
To FRONT L
To FRONT C
To FRONT R To SURROUND L
To SURROUND R
AM259777_02_V.pdf • April 23, 2002