User's Manual
Table Of Contents
- 00_Cover
- 01_AM799905_0020_ENG_print
- Getting Started
- Setting Up the System
- Using the Remote Control
- SoundTouch® App Setup
- Existing SoundTouch® Users
- Preset Personalization
- Bluetooth Technology
- Choosing your pairing method
- Connect your mobile device
- Pair a device with NFC
- Control your connected mobile device from the remote control
- Connect using the Bluetooth feature on your mobile device
- Connect using your remote control
- Disconnect a mobile device
- Pair another mobile device
- Reconnect a device
- Clear the system's Bluetooth pairing list
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: Installation Reference
- Front console panel
- Back console panel
- Connecting an OmniJewel™ base
- Installing the front speakers
- Connecting the front speakers to the console
- Attaching the rubber feet to your center speaker
- Connecting the center speaker to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Mounting your speakers
- Appendix B: System Maintenance
- Appendix C: Alternate Wired Setup
- 22_BCover
40 - ENGLISH
APPENDIX A: INSTALLATION REFERENCE
Identifying switch settings on wireless
receivers
Your rear speakers connect to wireless receivers to communicate with the console. The
receivers come preset to a left and right channel out of the box. You can use the switch
on the front of the receiver to adjust the channel settings.
1. Confirm that the switch on one wireless receiver is set to L (left).
2. Confirm that the switch on the other wireless receiver is set to R (right).
Note: Make sure that one wireless receiver is always set to L (left) and the other is set
to R (right).
Connecting the rear speakers
1. Place your speaker according to the “Placement guidelines” on page 12.
2. Connect and attach an OmniJewel™ base to an OmniJewel™ speaker
(see page 35).
3. Insert the other end of the two-pin cable into your wireless receiver.
You hear or feel a click.
4. Repeat steps 1 - 3 connect your other speaker.