User's Manual
Table Of Contents
- 00_Cover
- 01_AM799905_0020_ENG_print
- Getting Started
- Setting Up the System
- Using the Remote Control
- SoundTouch® App Setup
- Existing SoundTouch® Users
- Preset Personalization
- Bluetooth Technology
- Choosing your pairing method
- Connect your mobile device
- Pair a device with NFC
- Control your connected mobile device from the remote control
- Connect using the Bluetooth feature on your mobile device
- Connect using your remote control
- Disconnect a mobile device
- Pair another mobile device
- Reconnect a device
- Clear the system's Bluetooth pairing list
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: Installation Reference
- Front console panel
- Back console panel
- Connecting an OmniJewel™ base
- Installing the front speakers
- Connecting the front speakers to the console
- Attaching the rubber feet to your center speaker
- Connecting the center speaker to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Mounting your speakers
- Appendix B: System Maintenance
- Appendix C: Alternate Wired Setup
- 22_BCover
ENGLISH - 37
APPENDIX A: INSTALLATION REFERENCE
Connecting the front speakers to
the console
1. Place your speakers according to the “Placement guidelines” on page 12.
2. Connect and attach the OmniJewel™ bases to the OmniJewel™ speakers
(see page 35).
3. Insert the molded plug of the four-pin cable into the four-pin FRONT SPEAKERS
connector on the back of your console.
Attaching the rubber feet to your
center speaker
1. Remove the rubber feet from box .
2. Place the center speaker upside down on a soft, protected surface.
3. Remove the protective film from the feet.
4. Attach the rubber feet to the bottom of the center speaker at both ends.