User's Manual
Table Of Contents
- 00_Cover
- 01_AM799905_0020_ENG_print
- Getting Started
- Setting Up the System
- Using the Remote Control
- SoundTouch® App Setup
- Existing SoundTouch® Users
- Preset Personalization
- Bluetooth Technology
- Choosing your pairing method
- Connect your mobile device
- Pair a device with NFC
- Control your connected mobile device from the remote control
- Connect using the Bluetooth feature on your mobile device
- Connect using your remote control
- Disconnect a mobile device
- Pair another mobile device
- Reconnect a device
- Clear the system's Bluetooth pairing list
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: Installation Reference
- Front console panel
- Back console panel
- Connecting an OmniJewel™ base
- Installing the front speakers
- Connecting the front speakers to the console
- Attaching the rubber feet to your center speaker
- Connecting the center speaker to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Mounting your speakers
- Appendix B: System Maintenance
- Appendix C: Alternate Wired Setup
- 22_BCover
ENGLISH - 35
APPENDIX A: INSTALLATION REFERENCE
Connecting an OmniJewel
™
base
1. Using the screwdriver, turn the screws to the left (counterclockwise) to loosen the
wire terminals on the bases.
2. For front speakers: Insert the bare ends of the four-pin cable into the OmniJewel™
base by placing the red wire marked L+ or R+ into the red terminal ( + ) and the plain
wire into the plain silver terminal ( – ).
For rear speakers: Insert the bare ends of the two-pin cable into the OmniJewel™
base by placing the red wire marked + into the red terminal ( + ) and the plain wire
into the plain silver terminal ( – ).
3. Use the Phillips head screwdriver to secure the wires into the terminals by turning
the screws on top of the base to the right (clockwise).
4. While holding the OmniJewel™ speaker, place the base into the bottom.
The base should fit flush into your speaker, with the wire terminals facing the back.
5. Attach the base to the speaker by pushing the Phillips head screwdriver through the
circular opening and turning the screw to the right (clockwise) until fully seated.