Owner's Manual
Table Of Contents
- Owners Manual
- Table of Contents
- Getting Started
- Setting Up the System
- Using the Remote Control
- Setting Up SoundTouch
- Using the SoundTouch App
- Personalizing Your Presets
- Bluetooth Technology
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: installation reference
- Front console panel
- Back console panel
- Connecting an OmniJewel base
- Installing the front speakers
- Connecting the front speakers to the console
- Attaching the rubber feet to your center speaker
- Connecting the center speaker to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Making a wired connection to the rear speakers
- Mounting your speakers
- Appendix B: System Maintenance
ENGLISH - 35
APPENDIX A: INSTALLATION REFERENCE
Connecting an OmniJewel™ base
1. Using the screwdriver, turn the screws to the left (counterclockwise) to loosen the
wire terminals on the bases.
2. Insert the bare ends of the four-pin cable into the OmniJewel™ base by placing the
red wire marked L+ or R+ into the red terminal ( + ) and the plain wire into the plain
silver terminal ( – ).
3. Use the Phillips head screwdriver to secure the wires into the terminals by turning
the screws on top of the base to the right (clockwise).
4. While holding the OmniJewel™ speaker, place the base into the bottom.
The base should fit flush into your speaker, with the wire terminals facing the back.
5. Attach the base to the speaker by pushing the Phillips head screwdriver through the
circular opening and turning the screw to the right (clockwise) until fully seated.