User's Manual
Table Of Contents
- Getting Started
- Setting Up the System
- Using the Remote Control
- SoundTouch® App Setup
- Existing SoundTouch® Users
- Preset Personalization
- Bluetooth Technology
- Choosing your pairing method
- Connect your mobile device
- Pair a device with NFC
- Control your connected mobile device from the remote control
- Connect using the Bluetooth feature on your mobile device
- Connect using your remote control
- Disconnect a mobile device
- Pair another mobile device
- Reconnect a device
- Clear the system's Bluetooth pairing list
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: Installation Reference
- Front console panel
- Back console panel
- Connecting an AC-2 adapter
- Installing the front speakers
- Connecting the front speakers to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Mounting your speakers
- Appendix B: System Maintenance
- Appendix C: Alternate Wired Setup
36 - ENGLISH
Connecting an AC-2 adapter
1. Using the screwdriver, turn the screws to the left (counterclockwise) to loosen the
wire terminals.
2. For front speakers: Insert the bare ends of the four-pin cable into the adapter by
placing the red wire marked L+, C+ or R+ into the red terminal ( + ) and the plain
wire into the plain silver terminal ( – ).
For rear speakers: Insert the bare ends of the two-pin cable into the adapter by
placing the red wire marked + into the red terminal ( + ) and the plain wire into the
plain silver terminal ( – ).
Note: Be sure to only insert the bare ends of each exposed wire to avoid clamping
the wire’s insulation.
3. Using the screwdriver, turn the screws right (clockwise) to secure the wires into
the terminals.
4. Repeat steps 1 – 4 to connect the other adapter.
APPENDIX A: INSTALLATION REFERENCE