User's Manual
Table Of Contents
- Getting Started
- Setting Up the System
- Using the Remote Control
- SoundTouch® App Setup
- Existing SoundTouch® Users
- Preset Personalization
- Bluetooth Technology
- Choosing your pairing method
- Connect your mobile device
- Pair a device with NFC
- Control your connected mobile device from the remote control
- Connect using the Bluetooth feature on your mobile device
- Connect using your remote control
- Disconnect a mobile device
- Pair another mobile device
- Reconnect a device
- Clear the system's Bluetooth pairing list
- Advanced Features
- Getting System Information
- Care and Maintenance
- Troubleshooting
- Appendix A: Installation Reference
- Front console panel
- Back console panel
- Connecting an AC-2 adapter
- Installing the front speakers
- Connecting the front speakers to the console
- Installing the rear speakers
- Identifying switch settings on wireless receivers
- Connecting the rear speakers
- Connecting the rear speakers to power
- Mounting your speakers
- Appendix B: System Maintenance
- Appendix C: Alternate Wired Setup
ENGLISH - 33
TROUBLESHOOTING
Symptom Solution
Cannot play Bluetooth
audio
On your system:
• Pair a mobile device using the Bluetooth SOURCE screen.
• Clear the system’s pairing list using the remote control:
- In the Bluetooth source, press the MORE button on
your remote.
- Select Clear Pairing List.
• Try pairing a dierent mobile device.
On your mobile device:
• Disable and re-enable the Bluetooth feature.
• Remove the system from the Bluetooth menu. Pair again.
• Refer to your device’s documentation.
• See “No sound from the system” on page 31.
Setting up your IR emitter
If you are having issues with the responsiveness of your remote and your connected
devices, Bose® recommends using the provided IR emitter.
Note: Use the IR emitter only if you are having remote control issues from a third party
device.
1. Remove the IR emitter from box .
2. Insert the emitter into the IR connector on the back of the console.
3. Remove three adhesive pads from the plastic sheet included with the emitter and
place them on the flat bottoms of the three emitter beads.
4. Remove the plastic backing from the adhesive pads.
Emitter bead