Owner's Manual
Table Of Contents
- Quick Start Guide
- Owners Guide
- Reset
- Pairing
- Table of Contents
- Introduction / Features
- Unpacking the System
- Placement Guidelines
- Setting Up the Acoustimass Module
- Setting Up the Console
- Setting Up the Soundbar
- Connecting the System to Power
- Starting Up the System
- Finishing Setup
- Using the System
- Understanding messages on the display
- Troubleshooting
- Specs
- Universal Remote Device Codes
- Warranty
14 - English
Setting Up the Console
Connecting to non-HDMI™
compatible sources
If your source is non-HDMI compatible, connect it to your TV using audio and video
cables (available separately). Refer to your TV owner’s guide for more information.
Tip: If your source has IN and OUT audio connector panels, use audio OUT.
Audio-only sources
If your audio-only source, such as a media or CD player, is non-HDMI compatible,
connect it to the console’s optical, coaxial or analog connector. You can use an
optical, coaxial or analog cable (available separately).
Note: After connecting your audio-only source, you must set the optical, coaxial or
analog input for the appropriate source. You can access these settings using
the System menu (see page 27).