User Manual

End Product Labeling
This module is labeled with its own FCC ID and IC Certification Number. If the label is not visible
when the module is installed inside another device, then the outside of the device into which
this module is installed must also display a label referring to the enclosed module. In that case,
the final end product must be labeled in a visible area with the following:
“Contains Transmitter Module FCC ID: A94412568”
“Contains Transmitter Module IC: 3232A-412568”
or
“Contains FCC ID: A94412568”
“Contains IC: 3232A-412568”
IMPORTANT NOTE: In the event that these conditions can not be met (for certain
configurations or collocation with another transmitter), then the FCC and Industry
Canada authorizations are no longer considered valid and the FCC ID and IC
Certification Number can not be used on the final product. In that case the end
product must be re-evaluated to obtain separate FCC and Industry Canada
authorizations.
In addition, Information regarding how to install or remove this RF module or change its
RF related parameters should not be provided to the end user.
The user manual for the end product must include the following information in a
prominent location:
“To comply with FCC and Industry Canada RF radiation exposure limits for general
population/uncontrolled exposure, the antenna(s) used for this transmitter must be
installed such that a minimum separation distance of 20cm is maintained between the
radiator (antenna) and all persons at all times. In addition this transmitter must not be
collocated or operating in conjunction with any other antenna or transmitter.”
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio
peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur)